+86 769 81090126
Categories
Cart 0 items
Your cart is empty
  • Electronic LED Falshing Lights Soldering Practice Board PCB DIY
  • Electronic LED Falshing Lights Soldering Practice Board PCB DIY
  • Electronic LED Falshing Lights Soldering Practice Board PCB DIY
  • Electronic LED Falshing Lights Soldering Practice Board PCB DIY
  • Electronic LED Falshing Lights Soldering Practice Board PCB DIY

The LED light flows from the inside to the outside, creating the effect of the exploding water lamp.The speed of LED flow can be adjusted to meet various demands. High quality PCB,Even beginners can easily weld successfully.

Installation Steps:
1.Install RES: 200 ohm resistor install on R2-R10 pad, 1K ohm resistor installed to R1, R2- R10 pad. 10K ohm resistor installed to R21 pad
2.Install a red LED to D1
3.Left to right, red, yellow, red, yellow in order to install LED. The LED's anode corresponds to the square pad
4.Red-yellow-red-yellow continues to install LED
5.Installation completes all LED
6.Install adjustable resistance cap, electrolytic capacitor and DC power socket
7.Install S9013 triode to Q1-Q10 position pads
8.Install integrated circuit. Be careful pin direction
9.Solder the battery box red line on the VCC. The black line is weldered to the GND. Check the direction of the PCB capacitor

Electronic LED Falshing Lights Soldering Practice Board PCB DIY

EK1874

The LED light flows from the inside to the outside, creating the effect of the exploding water lamp.The speed of LED flow can be adjusted to meet various demands. High quality PCB,Even beginners can easily weld successfully. Installation Steps: 1.Install RES: 200 ohm resistor install on R2...
  • Shipping Weight: 68g
  • Manufactured by: gikfun
82 Units in Stock
$11.28

Current Reviews: 0

This product was added to our catalog on Thursday 28 September, 2017.