+86 769 81090126
Categories
Cart 0 items
Your cart is empty

Module parameters:

1.A single module can drive an 8 * 8 common cathode lattice
2.Module Operating voltage: 5V.
3.Module size: 5 cm long X 3.2 cm wide X 1.5 cm high
4.With four screws hole, aperture 3mm, by using our M3 Tongzhu fixed
5.Module with input and output interfaces, supports multiple modules cascade

Wiring instructions:
1.The module left as an input port to the output port on the right.
2.The control of a single module, simply input port to the CPU
3.Multiple modules cascade input termination CPU, 2 output termination module, a module of the input of the input terminal, the output terminal of the first two modules of the first three modules, and so on ...


51 MCU, for example:
VCC   5V
GND   GND
DIN   P22
CS   P21
CLK   P20

Package:

1 MAX7219 Dot matrix module MCU control Display module DIY Kit (Not Assembled) 

Note:

1.VCC and GND is not reversed, it would burn the chip!
2.When the 51 microcontroller P0 port control, must be connected to the pull-up resistor, it is recommended that the resistance of 4.7K--10K.
3.Please lattice into the hole first seat, and then inserted into the round hole Block PCB board welding. Lattice word side facing the surface order from left to right pin 123456. PCB board 1 foot square pad!
4.Electrolytic capacitors long-legged as positive, negative short legs; ceramic capacitor without the positive and negative points.

 

MAX7219 Dot matrix module MCU control Display module DIY

EK1100

Module parameters: 1.A single module can drive an 8 * 8 common cathode lattice 2.Module Operating voltage: 5V. 3.Module size: 5 cm long X 3.2 cm wide X 1.5 cm high 4.With four screws hole, aperture 3mm, by using our M3 Tongzhu fixed 5.Module with input and output interfaces, supp...
  • Shipping Weight: 32g
  • Manufactured by: gikfun
3 Units in Stock
$3.58

Current Reviews: 0

This product was added to our catalog on Tuesday 27 September, 2016.