+86 769 81090126
Categories
Cart 0 items
Your cart is empty

belong to you modules

  • 2PCS Micro USB Charger with 2 Pin Charging Cable for Arduino
    2PCS Micro USB Charger with 2 Pin Charging Cable for Arduino
    Easily charge 3.7V LiPo cells at a rate of 500mA. It is designed to charge single-cell Li-Ion or Li-Polymer batteries. The board incorporates a charging circuit, status LED, connector for your battery (JST-type used in the batteries we carry), and a micro-USB connector. A small mounting hole allows this charger to be easily embedded into a project. Easily charge 3.7V LiPo cells at a rate of 500mA. It is designed to charge sing...
  • 2pcs new NRF24L01 2.4GHz RF Wireless Transceiver Module
    2pcs new NRF24L01 2.4GHz RF Wireless Transceiver Module
     NRF24L01 + 2.4GHz RF Wireless Transceiver Module NRF24L01 is a single chip radio transceiver for the world wide 2.4 - 2.5 GHz ISM band. The transceiver consists of a fully integrated frequency synthesizer, a power amplifier, a crystal oscillator, a demodulator, modulator and Enhanced ShockBurst? protocol engine. Output power, frequency channels, and protocol setup are easily. programmable...  NRF24L01 + 2.4GHz RF Wireless Transceiver Module NRF24L01 is a single chip...
  • 2x100W TPA3116 D2 Dual Channel Digital Audio Amplifier Board
    2x100W TPA3116 D2 Dual Channel Digital Audio Amplifier Board
    Product description: Chip:TPA3116 Power supply: 12V-24V Channel Type:Dual Channel Output power: 2*100W Input impedance:51K*2 Output Match:4-8 Ohm Frequency Range:14-100Kz SNR:100db Product description: Chip:TPA3116 Power supply: 12V-24V Channel Type:Dual Chann...
  • 3.3-5V Logic Level Converter Bi-directional Shifter Module
    3.3-5V Logic Level Converter Bi-directional Shifter Module
    If you've ever tried to connect a 3.3V device to a 5V system, you know what a challenge it can be. The bi-directional logic level converter is a small device that safely steps down 5V signals to 3.3V AND steps up 3.3V to 5V at the same time. This level converter also works with 2.8V and 1.8V devices, is very easy to use. Each level converter has the capability of converting 4 pins on the high... If you've ever tried to connect a 3.3V device to a 5V system, you know what a c...
  • 3PC Nano V3.0 ATmega328 controller Board CH340G USB Driver
    3PC Nano V3.0 ATmega328 controller Board CH340G USB Driver
     CH340G REPLACE FT232RL Operating Voltage(logic level):5V 8 analog inputs ports:A0 ~ A7 14 Digital input / output ports:TX,RX,D2 ~ D13 6 PWM ports:D3, D5, D6, D9, D10, D11 1 pairs of TTL level serial transceiver ports RX / TX Using Atmel Atmega328P-AU MCU Support USB download and Power Support for external 5V ~ 12V DC power supply Support power supply by 9V battery  CH340G REPLACE FT232RL Operating Voltage(logic level):5V 8 analog inputs ...
  • 4 Bits Digital Tube LED Display Module
    4 Bits Digital Tube LED Display Module
    The module is a 12 foot with a clock point four common anode tube (0.36 in.) display module for driver IC TM1637, only two signal lines can make the MCU control 4 8 digital tube. Module features are as follows: 1. Display common anode for the four red LED 2. Digital tube 8 gray adjustable 3. Level control interface for 5V or 3.3V 4. Size:42X24X12mm The module is a 12 foot with a clock point four common anode tube (0.36 in.) dis...